The Monit magnetic mount antenna is a high-sensitivity GPS/GNSS antenna that is tuned specifically to provide maximum accuracy for the Monit G-Series+ rally computers. With a strong magnet built into the base, the GPS antenna can clamp onto the steel roof of a vehicle, simplifying installation and removal.
For gravel events or high performance vehicles the addition of high bond adhesive tape is recommended to prevent excessive movement.
Note: To achieve the best performance from the new G-Series+ rally computers it is essential to use a genuine Monit GPS/GNSS antenna that is manufactured in 2019 or later.
The Monit bulkhead mount antenna is a high-sensitivity GPS/GNSS antenna with an integrated screw mounting stud and nut. This can be used to securely fasten the antenna through a vehicle’s roof or to a suitable mounting bracket. The mounting stud and antenna housing are sealed to prevent water ingress if a hole is made in the roof to accommodate the low profile antenna.
Note: To achieve the best performance from the new G-Series+ rally computers it is essential to use a genuine Monit GPS/GNSS antenna that is manufactured in 2019 or later.
The Monit inductive wheel probe works by detecting the presence of metal as it is brought near the end of the sensor. It is typically fitted to a vehicle’s wheel hub so that it senses the back of the wheel studs or other metal detection targets as they rotate past. In this way, it can be used to measure speed and distance on a wide variety of modern, classic and historic vehicles.
Suitable for all types of vehicles that do not have a factory fitted speed sensor.
The speed sensor interface allows you to use a gearbox or differential mounted factory electronic speed sensor to operate a Monit rally computer. It will work with most types of sensors, and signals, that produce either an analogue or digital pulse output. The interface contains special noise filtering circuitry to prevent interference and eliminate ground loop problems.
The ABS interface takes the signal produced by an ABS Wheel Speed Sensor and converts it into a format that can be used to operate a Monit rally computer. It will work with most types of two wire ABS sensors that generate an analogue output signal.
The interface can only be used with ABS wheel speed sensors that have been disconnected and are no longer used by the vehicle’s safety systems. It must not be fitted to any vehicle that still uses its ABS system.
With its careful selection of essential features, the Monit G-100+ model is the perfect entry-level rally computer for professional rally teams. The compact and light-weight design combined with the simple installation afforded by GPS make it easy to fit into any modern, classic or historic rally vehicle.
It is also ideal for use in rally reconnaissance (recce) vehicles.
The premium Monit G-200+ rally computer has all the features required for the highest level of competition, with the same simple-to-use design as the G-100+. Used by leading rally teams around the World, the Monit G-200+ is the ideal choice for competitors that demand the most from their equipment.
Our most affordable rally computer, the Monit Q-10 is ideal for club-competitors on a budget, or specialised events where only basic distance measurement is allowed. The Q-10 has two accurate five-digit distance counters that can be individually cleared.
The Monit Q-20 rally computer has the same two distance counters as the Q-10, but with the addition of current and average speed measurements. Ideal for club-competitors involved in blind, pace note, or regularity type events.
This site uses cookies to provide you with a better browsing experience. By accepting this banner, scrolling down this page, clicking on a link, or continuing to browse in any other way, you consent to the use of cookies.
